View Single Post
Old September 27, 2013, 07:38 PM   #25
North East Redneck
Senior Member
 
Join Date: June 6, 2012
Location: Berkshire Hills
Posts: 501
Doc, thanks man. Things are looking better. The short story is, it is a question of home insurance for a home that's being renovated. I believe between the lawyer, the lending institution and the ins company, everything is set to move toward closing.

I also received the R&D conversion cylinder from Taylors. Bolt won't lock up. Contacted Taylors, they said to send the gun or the bolt in. Free of charge they will adjust the bolt.
I'm new to this but I believe the bolt is unable to lock on firing due to the bolt stops in the cylinder being cut less deep than the BP cylinder bolt stops. This is causing the bolt to not lock into place upon bringing the gun to full cock. So a simple small job of grinding of the bolt cam should fix the problem.
__________________
NRA Life Member
Goal Member
SAF Member
North East Redneck is offline  
 
Page generated in 0.04297 seconds with 7 queries