View Single Post
Old August 18, 2013, 09:26 PM   #11
johnroy
Junior Member
 
Join Date: August 24, 2011
Location: Alpine, TX the Big Bend
Posts: 5
RCBS auto 4x4 press setup

Coz, On the RCBS case activated kit, does the RCBS kit work with the Lee powder measure or will the Lee case activated powder drop and the Lee powder measure work with the press by themselves. I have the Lee and was able to get consistent plus or minus a tenth of a grain on the progressive press. Mostly a case of finding a volume that gave the correct weight. Tapping the lever arm a couple of times at the top and bottom of each stroke seemed to be the real key to consistency. Of course, all of the measures work on a volume unless you get the electronic version. That said, I used the Uniflo on the single stage press for rifle loads. I think there was some movement in the adjustment that would vary a little bit until it settled down. In the bigger cases the extra tenth didn't seem to make that much difference.
johnroy is offline  
 
Page generated in 0.04184 seconds with 7 queries