View Single Post
Old August 15, 2013, 06:46 PM   #5
Dfariswheel
Senior Member
 
Join Date: May 4, 2001
Posts: 6,817
I don't see how the trigger and hammer pin wire could cause this problem, but it's at least possible if the wire was installed wrong.

The more or less "standard" trigger unit for AK's is the excellent Tapco G2.
This is available as a single or double hook, depending on your receiver.
There's no advantage to either a single or double hook, so just buy the one that matches the receiver cuts in the trigger hole in the bottom of the receiver.
Dfariswheel is offline  
 
Page generated in 0.04653 seconds with 7 queries