View Single Post
Old August 4, 2013, 11:59 AM   #4
Dixie Gunsmithing
Senior Member
 
Join Date: April 27, 2013
Location: Ohio
Posts: 788
These little pins have a beveled end on one end, which should be aimed down, so you would drive it out from the bottom up. They generally swell the head or bump this type of pin, for a tight fit, so you drive them out from the beveled end. Just use a punch a shade smaller than the diameter, and a 6 oz. ball pein to tap it out. Last, watch to not loose the spring.
Dixie Gunsmithing is offline  
 
Page generated in 0.04076 seconds with 7 queries