View Single Post
Old August 4, 2013, 09:53 AM   #1
Gataochii
Junior Member
 
Join Date: September 30, 2012
Location: Eastern Indiana
Posts: 7
Iver Johnson TP22 extractor

Had to purchase a new extractor, as the old one wore the "catch" off and would no longer pull and eject the spent casing. (I have to add, I was lucky as hell to find one NOS). So, now that I have the damned thing, I'm at a loss as to how to safely remove the pin that holds it in place. I attempted to push it out with an old tiny drill bit, but it's really in there tight and I'm afraid of damaging it to the point where it can't be re-used. (because, of course, the supplier that had the extractor is out of stock on the pin...) I don't WANT to hammer it out, but it looks like it's my only option at this point.

Any ideas or suggestions? I miss my little .22.....



edit-added pic of the offending part

Last edited by Gataochii; August 4, 2013 at 10:12 AM.
Gataochii is offline  
 
Page generated in 0.04594 seconds with 7 queries