View Single Post
Old August 1, 2013, 09:19 AM   #12
Dixie Gunsmithing
Senior Member
 
Join Date: April 27, 2013
Location: Ohio
Posts: 898
Alex,

I already have a lathe and a turret mill, it's just that I like the small size of this, and thought it would be good for smaller jobs, especially the horizontal milling capacity. By the looks of it, it will fit within a 2' x 2' cube, and that would fit well with what I would like to do, and where I have a place for it. The motor HP, though is 1/2, but its speed is stepped down by about 1/2, or a little more, by belt, so the torque should be a good bit. But as you said, the electrical does look cheaper made than those manufactured in the US.
Dixie Gunsmithing is offline  
 
Page generated in 0.06160 seconds with 7 queries