Thread: 45ACP help
View Single Post
Old July 24, 2013, 10:05 PM   #4
Hundy
Senior Member
 
Join Date: February 23, 2013
Posts: 106
Not taken wrong, thank you for reply

I did full length the brass, with the sizer die. I measured a few after and they were withing the specs in the speer book. I did not measure them all. There may lie my problem.
As far as the handgun, I just got it back from the manufacturer, it was being serviced, I have had it since 1993. The chamber is clean.
I guess I should have measured all the brass. Lesson learned.
Thank you for your reply, no part of your questions was taking the wrong way, I appreciate you asking them to help. In the case I think your question, answered my original question.

Thank you again

Jay
Hundy is offline  
 
Page generated in 0.04203 seconds with 7 queries