View Single Post
Old July 23, 2013, 12:57 PM   #1
Dixie Gunsmithing
Senior Member
 
Join Date: April 27, 2013
Location: Ohio
Posts: 693
Mini-Mill for shop

Has anyone tried out the mini-mill below yet, or know anyone who has? I am thinking seriously about buying one to make small gun parts on, but I am wondering what others have found with it so far.

It looks like it could handle almost anything, with lighter cuts, even fluting pistol barrels.


Mini-Mill by matneyw, on Flickr
Dixie Gunsmithing is offline  
 
Page generated in 0.04234 seconds with 7 queries