Thread: Grip expert
View Single Post
Old July 5, 2013, 03:10 PM   #5
PetahW
Senior Member
 
Join Date: September 19, 2008
Posts: 4,679
.

FWIW, the only yellowed plastic grips were made that way.

The gun might have real Ivories on it, so why don't you test them (on the inside surface) ?

Heat a pin or small nail with a sharp point (hold it w/pliers) and apply the hot point to the grip surface - the hot tip will melt/penetrate the surface of plastic, but not Ivory.



.
PetahW is offline  
 
Page generated in 0.04584 seconds with 7 queries