View Single Post
Old July 2, 2013, 10:39 PM   #7
Bart B.
Senior Member
 
Join Date: February 15, 2009
Posts: 4,643
Slamfire's of the opinion that a manufacturer should build his firearm so the firing pin strike is in the middle of the primer. That would be great.

But it also means case makers need to have their primer pockets exactly in the middle of the case. And case wall thickness be exactly the same all the way around. Plus zero fit tolerance in the bolt body to the receiver boltway.

Then the barrel tenon threads have to be exactly centered with the boltway axis. The hole in the bolt face has to be dead centered there. And the bold shroud around the bolt face has to be exactly the same diameter of the case rims used.

Finally, the case body diameter in front of the extractor groove has to be the same diameter as the chamber at that point so it centers perfectly at that point.

I may have forgot one or other dimensional issue that has to have zero tolerance, if so, sorry 'bout that.
__________________
US Navy Distinguished Marksman Badge 153
Former US Navy & Palma Rifle Team Member
NRA High Power Master & Long Range High Master
NRA Smallbore Prone Master
Bart B. is offline  
 
Page generated in 0.04816 seconds with 7 queries