View Single Post
Old July 2, 2013, 12:16 PM   #35
Dixie Gunsmithing
Senior Member
 
Join Date: April 27, 2013
Location: Ohio
Posts: 901
One thing I might recommend on this, if you are not going to have the revolver where it could gather dirt inside, is you might apply a little thin white moly grease on the safety linkage. If its in a clean enough environment, it wont trap dirt, and help that slide. I always ask the owner first on this, but if it will be kept clean, then I add that. Also, a small drop of oil on the hammer and trigger pins, the cylinder bolt screw, rebound lever pin, and the hammer stirrup pin, will free things up a bit too. I use a needle oiler for this.
Dixie Gunsmithing is offline  
 
Page generated in 0.03901 seconds with 7 queries