View Single Post
Old June 15, 2013, 09:41 PM   #2
Unclenick
Staff
 
Join Date: March 4, 2005
Location: Ohio
Posts: 10,327
With the exception of the Lee locking rings, which you set each time, standard lock rings have a set screw or a cross-bolt screw to fix their positions on the die. This is intended to relocate them to the same place each time. However, you want to check a test round with them each time to be sure you didn't get them tightened a little differently than at the previous session. After while you'll get the feel of it.
__________________
Gunsite Orange Hat Family Member
CMP Certified GSM Master Instructor
NRA Certified Rifle Instructor
NRA Benefactor Member
Unclenick is offline  
 
Page generated in 0.04156 seconds with 7 queries