Thread: Tingle MFG. CO.
View Single Post
Old June 11, 2013, 11:16 PM   #18
thickice
Member
 
Join Date: December 15, 2009
Location: Texas
Posts: 56
AIR, this was a long time ago, there was a stud on the stock that fit into a slot in the backstrap. There was a J shaped rod that ran down a hole behind the metal stud. The short J part fit into a depression on the bottom of the grip frame and it was tightened by a thumb screw at the top of the long shaft.
thickice is offline  
 
Page generated in 0.04954 seconds with 7 queries