View Single Post
Old June 1, 2013, 05:08 PM   #10
III-Percent
Member
 
Join Date: May 18, 2013
Location: Hillsboro, OR
Posts: 30
Haha thats good to know - does this mean that I can only use Sig parts to replace the Hammer, Trigger, etc. since Sig 1911's aren't milspec?

Really hope I can get it all fixed up. Will be finishing the disassembly this evening, then going to look for a local company that can bead blast it. After that its just about buying new parts and getting the frame and receiver finished with cerakote.

By the way - yours is definitely a good example of how the pistol SHOULD look when you take care of it haha - assuming you probably didn't use needle nose pliers and a screwdriver to try and take it apart
__________________
"It does not take a majority to prevail... but rather an irate, tireless minority, keen on setting brushfires of freedom in the minds of men." - Samuel Adams

Last edited by III-Percent; June 1, 2013 at 05:14 PM.
III-Percent is offline  
 
Page generated in 0.04774 seconds with 7 queries