View Single Post
Old May 27, 2013, 05:10 PM   #4
III-Percent
Member
 
Join Date: May 18, 2013
Location: Hillsboro, OR
Posts: 30
Removing Finish

Sorry for the double post but figured I could ask here rather than making a new thread: for removing the finish on this pistol, while I may still bead blast it, I was curious if there are alternative methods that may be cheaper? I really don't want to mail it in to a company and bead blasting equipment can get expensive - I would invest in it if I knew for a fact I would need to use it again in the future but I have no idea if I will or not. Any ideas?
__________________
"It does not take a majority to prevail... but rather an irate, tireless minority, keen on setting brushfires of freedom in the minds of men." - Samuel Adams
III-Percent is offline  
 
Page generated in 0.05159 seconds with 7 queries