View Single Post
Old May 16, 2013, 07:24 PM   #7
Mausermolt
Senior Member
 
Join Date: June 16, 2007
Location: Ory-gun
Posts: 502
well after cocking, putting the safety on, squeezing the trigger to make sure the safety functioned the then when i took the safety off the hammer would drop ....so yeah it needed replaced. Also i replaced the barrel because the barrel link hanggy down holder thingy had gotten damaged somehow and the link was pinched a bit keeping it from swinging freely.

"....a good quality 1911..." remember we are talking about a AO here :P

yes i have tweaked the extractor so it is properly holding the cartridge against the slide. as i remember it it is to hold it enough to keep it in place while rotating it, but if you give it a bit of a shake then the round should fall out.

side note:the round count could very well be MUCH higher, just sayin i have personally witnessed about 13K rnds go through the pipe.
__________________
Molon Labe

Last edited by Mausermolt; May 16, 2013 at 07:30 PM.
Mausermolt is offline  
 
Page generated in 0.04375 seconds with 7 queries