View Single Post
Old May 11, 2013, 08:36 PM   #3
Dixie Gunsmithing
Senior Member
 
Join Date: April 27, 2013
Location: Ohio
Posts: 948
It was most likely a case of the screw not having the proper torque applied when it was installed, and simply worked its way out over time. I have seen this on a few new guns out of the box. I guess the guys just forgot to snug them up when they were being assembled.

The only other thing I can think of, is to ask if you have took the gun down, to make sure the head hasn't broken off the screw, and it's shank still threaded in the hole?
Dixie Gunsmithing is offline  
 
Page generated in 0.04812 seconds with 7 queries