View Single Post
Old May 11, 2013, 01:52 PM   #2
Dixie Gunsmithing
Senior Member
 
Join Date: April 27, 2013
Location: Ohio
Posts: 939
It should come off. Evidently, there is some stock finish, etc., under the butt plate, that has bonded with the plate itself. Mount the stock in a vise, in a way it wont get scratched. Next, take a rubber mallet, and sharply rap the edge of the butt plate, and see if that will break it loose. If not, try heating the butt plate with a hair dryer, and then giving it a rap.
Dixie Gunsmithing is offline  
 
Page generated in 0.04110 seconds with 7 queries