View Single Post
Old May 11, 2013, 05:40 AM   #1
NSC
Junior Member
 
Join Date: May 10, 2013
Posts: 3
How to remove the butt plate on an Anschutz 1416?

I am trying to remove the butt plate from my Anschutz 1416. I have removed the two screws and there are no other screws evident but the butt plate is still firmly fixed to the stock. I have also carefully tried to prise a knife blade between the butt plate and the stock but only managed to scratch the stock. Any ideas what to do next? The reason I am removing the butt plate is to increase the length of pull by about 2"/50mm (I have long arms!) so any suggestions about other ways to increase the length of pull would also be gratefully received.
NSC is offline  
 
Page generated in 0.05125 seconds with 7 queries