Thread: MAK*90 vs AK-47
View Single Post
Old May 7, 2013, 08:00 PM   #13
dsk
Senior Member
 
Join Date: June 19, 2001
Posts: 1,550
A long time ago I had a Chinese MAK-90 with a milled receiver, and when I tried to put standard AK furniture on it I discovered that the bottom rear of the receiver was milled away and had no mounting tang. I eventually made my own stock and used a bolt/washer and nut that went through into the receiver at the rear, but it was a pretty hokey setup and I sold the rifle a short time later. I believe there may be companies out there that make a replacement stock set that will actually fit a MAK-90 receiver.
dsk is offline  
 
Page generated in 0.03860 seconds with 7 queries