View Single Post
Old May 7, 2013, 11:57 AM   #23
Noz
Senior Member
 
Join Date: February 25, 2009
Posts: 643
If you get to the point of still wanting to chamfer your chambers, reach for a Lee tool produced to chamfer the mouth of cartridges. It is a hard steel that will cut you chambers easily. A couple of twists will break the sharp edge and solve your problems. Unless you grind on it with both hands you cannot do any damage to the gun.
Just go lightly until the desired configuration is reached.
Noz is offline  
 
Page generated in 0.04928 seconds with 7 queries