View Single Post
Old May 4, 2013, 06:07 PM   #14
brazosdave
Senior Member
 
Join Date: September 7, 2012
Location: Copperas Cove, TX
Posts: 282
I don't know who the manufacturer of your gun was,but I have an ASM .31 and ended up going between .319-.321 and it worked cool, I tried the .315's like it said to and had the same problem as you. I got a Wells Fargo, so no rammer, but I pound the balls into the cylinder with a small wooden mallet and finish it with a piece of dowling I got in the arts and crafts aisle at wall mart. It's cheap chinese pine or somethin, so you have to make a new one every now and then, but a couple ft. of that wood rod is like less than a dollar, and you get quite a few pencil lenght pieces out of it. It's so reliable now, I carry it from time to time.
__________________
"I'm your huckleberry, it's just my game"
brazosdave is offline  
 
Page generated in 0.04611 seconds with 7 queries