Thread: .357sig
View Single Post
Old May 4, 2013, 12:18 PM   #60
tulsamal
Senior Member
 
Join Date: October 25, 2004
Location: Vinita, OK
Posts: 2,467
Quote:
I only wish they made a carbide sizing die for the .357 Sig that was priced a bit below $100 bucks!
I was using a combination of .40 S&W carbide dies and standard .357 SIG dies. It worked but it took multiple passes.

Then I saw a guy selling "like new" Dillon carbide .357 SIG dies for $70 shipped. I jumped on that and they are out in my reloading area. I haven't actually _used_ them yet but I'll get around to it one of these days!

Gregg
tulsamal is offline  
 
Page generated in 0.03863 seconds with 7 queries