View Single Post
Old May 1, 2013, 01:18 PM   #8
e-bear
Member
 
Join Date: October 18, 2008
Location: Virginia
Posts: 57
Thank you, eldermike and Brian, I was and still am wondering about the variations in Plated bullets from Rainier.

Labelled as 147GR but actually 145.4GR to 146.6GR. I did not weigh any that weighed 147GR. and all were.354 diameter not .355 diameter. Is this normal in bullet manufacturing?

As far as the variations in length of bullet is concerned I am afraid to set the bullet deeper to achieve the proper OAL.

Maybe its just me but I would rather err on the side of caution and be perceive as a dummy than be a dummy and cause a mishap at the range.
Thanx again for your input.
__________________
'If we ever forget that we're one nation under God, then we will be a nation gone under.'- Ronald Reagan
"Denying me a gun because idiots kill is like getting castrated because your neighbor has too many kids." - Andy
e-bear is offline  
 
Page generated in 0.04075 seconds with 7 queries