View Single Post
Old April 24, 2013, 04:52 AM   #2
PetahW
Senior Member
 
Join Date: September 19, 2008
Posts: 4,679
I've never seen a 12ga bore guide, but in the event one's made by someone, I doubt it's needed.

Bore guides are to keep nearly-bore-sized, or flexing, cleaning rods from rubbing against the rifling @ the muzzle (usually) - and a 12ga bore (.729") is over 2x bigger than a 12ga cleaning rod, which don't usually flex much anyway.

A slug gun with a rifled barrel's still just a rifle, but bigger than most (.72 cal)
I just use a 12ga bronze brush in mine to get rid of any melted plastic from the sabots, then finish up with a bore cleaner on patches.



.
PetahW is offline  
 
Page generated in 0.03936 seconds with 7 queries