Thread: Burned Brass
View Single Post
Old April 20, 2013, 08:18 PM   #7
gwpercle
Senior Member
 
Join Date: November 30, 2012
Location: Baton Rouge, Louisiana
Posts: 117
fshfindr,
Do as Scott suggest and bump up your powder charge a bit, you are not getting enough pressure. When you get a bit higher pressure the sooty case will stop and you might notice a cleaner burn ( less crud left in barrel and action. Too little pressure causes problems just like too much pressure causes problems.
Keep an eye out for jacketed bullets and low pressure loads...sometimes the bullet will stick in the barrel ...and if you shoot again..Trouble.

Gary
gwpercle is offline  
 
Page generated in 0.06481 seconds with 8 queries