View Single Post
Old April 19, 2013, 09:06 PM   #32
dacaur
Senior Member
 
Join Date: March 16, 2010
Posts: 733
When I adjusted mine, I took the rod out of the press, then used the 1/4" wrench on the indexing rod, then found another wrench that fit the top square part, rather than trying to do it in the press... Took a couple tries to get it just right, but I didn't think it would be a good idea to put a lot of pressure on the aluminum turret.....
dacaur is offline  
 
Page generated in 0.04471 seconds with 7 queries