View Single Post
Old April 17, 2013, 03:59 PM   #6
BigJimP
Senior Member
 
Join Date: February 23, 2005
Posts: 11,227
I think high primers are you're most likely culprit.../ especially if the cyclinder is rotating properly when the gun is empty.

If the primers all look good ...then I think you'll have to have someone local look at the gun - but I wouldn't send it anywhere....I'd try to find someone locally ....that could look at the cyclinder hand in the action - and a number of pins - and springs in the action.

But in the meantime ....make sure the gun is clean and lubed properly.
BigJimP is offline  
 
Page generated in 0.04467 seconds with 7 queries