View Single Post
Old April 14, 2013, 05:49 PM   #5
deckard
Member
 
Join Date: March 16, 2013
Posts: 25
So on closer inspection on the bore alignment, the slide is laughably angled left at the front, causing the barrel bushing to sit with a gap on it.

I'm not sure if this is a manufacturing defect or if the previous owner dropped the gun, somehow I don't see how dropping the gun could cause this, so I'm going with manufacturing defect.

Pic: https://www.copy.com/s/Bqdrgf3XFaQA

Think I'll try mucking with the bushing to make it shoot straight.

Last edited by deckard; April 16, 2013 at 12:36 PM.
deckard is offline  
 
Page generated in 0.04641 seconds with 7 queries