View Single Post
Old April 10, 2013, 12:38 PM   #1
Skitter
Senior Member
 
Join Date: March 5, 2013
Location: NW Houston TX
Posts: 156
Make your own Handgun Grips

Limited on tools, but I can sand as needed, I have a rotozip to cut out the pattern. I have been finding it can be rather difficult to find grips for my specific handgun.

That being said, I figure I can trace the old ones, countersink the holed if needed. But what kind of wood/bone can be used? How to you "harden" it so that it's going to last as long as possible? What kind of finish do you generally use?

Thanks!
__________________
Raised with guns only to realize how much I DIDN'T know. Newly acquired personal inventory is increasing, feed my obsession for knowledge!
Skitter is offline  
 
Page generated in 0.05255 seconds with 7 queries