Thread: 9mm reloads
View Single Post
Old April 8, 2013, 06:32 PM   #6
NoSecondBest
Senior Member
 
Join Date: December 7, 2009
Location: Western New York
Posts: 838
If you mean that your slide won't close when you attempt to chamber a round, your crimp is not right. If this is the case, are you using a taper crimp die or a roll crimp die. Using a roll crimp will often cause problems and for any round going into an auto, a taper crimp will always be the way to go. Especially on the 9mm and 38Super type shells.
NoSecondBest is offline  
 
Page generated in 0.04293 seconds with 7 queries