View Single Post
Old April 6, 2013, 07:34 PM   #1
ocracokenc
Member
 
Join Date: February 18, 2013
Posts: 19
Cleaning Lee carbide pistol dies

I was wondering if anybody cleans their dies? I have the Lee 45acp, 40sw/10mm carbide dies and I use the lee sizing lube mixed 10 to 1 with alcohol. I started to use lube after reading the Lee reloading manual. In it he says that with really clean brass it can help to use his lube mixed 10 to 1. I have been using wooden q-tips and straight alcohol and then a small amount of Rem-oil on a q-tip then several to remove all the residue. I am wondering if this can cause problems or is it ok? I do it after every use. Thanks
ocracokenc is offline  
 
Page generated in 0.04204 seconds with 7 queries