Thread: Tolerances
View Single Post
Old April 6, 2013, 11:18 AM   #5
Unclenick
Staff
 
Join Date: March 4, 2005
Location: Ohio
Posts: 9,997
Most trim-to lengths are actually right in the middle of the tolerance so a manufacturer has maximum room for error either side of it. If you measure new bulk brass you'll find home trimming is usually more precise than factory, so we can cut a little more, as some do in order not to have to do it again so soon, or a little longer, as some do to better grip bullets seated out long for single loading accuracy.
__________________
Gunsite Orange Hat Family Member
CMP Certified GSM Master Instructor
NRA Certified Rifle Instructor
NRA Patron Member
Unclenick is offline  
 
Page generated in 0.04594 seconds with 7 queries