View Single Post
Old April 4, 2013, 06:48 PM   #5
pre64win
Junior Member
 
Join Date: July 29, 2010
Location: Texas
Posts: 7
If you are using a Lee type factory crimping die with a carbide insert that may be your problem. This die may be sizing the loaded round enough to reduce the diameter of the cast bullet enough that it is too small to fit your barrel.
The lead bullet will not rebound from the compression like brass will. If you are using one of these dies tray a few loads crimped with the seating die and see if that solves the problem.
pre64win is offline  
 
Page generated in 0.04455 seconds with 7 queries