View Single Post
Old April 1, 2013, 09:56 PM   #1
Eppie
Senior Member
 
Join Date: January 7, 2010
Location: Houston, TX
Posts: 792
Need to modify a neck turning adapter

Hi Guys,
I have a Hornady LnL Case Prep Center and it has turned out to be a very useful tool, now I want to make it even better so I can turn necks on my 308 brass.

I've purchase a shellholder driver adapter from 21st Century and it has a stem that fits into a drill, however I think it will work much better if I can screw it into my Case Prep Center because it is a nice slow speed.

My question is this: How do I go about finding a machine shop that can alter the drill stem into a screw like the bore brush or chamfering tool?

Attached Images
File Type: jpg Driver 3.jpg (97.1 KB, 26 views)
__________________
"Socialized Medicine is the Keystone to the Arch of the Socialist State.” -Vladimir Lenin
"I predict future happiness for Americans if they can prevent the government from wasting the labors of the people under the pretense of taking care of them." - Thomas Jefferson (An early warning to Obama care)
Eppie is offline  
 
Page generated in 0.04805 seconds with 8 queries