View Single Post
Old March 31, 2013, 09:24 PM   #9
bustersmaster
Senior Member
 
Join Date: February 8, 2006
Posts: 182
These do seem to vary according to the gun you're working with. These guns were all made before CNC machining became the standard for gun manufacturers. I think there is probably some variance between SKS's made in the same country. It's a lot easier to file a little plastic down to relieve a too tight fit than it is to add material to a loose fit.
As I recall, I had to do the same to mine and now it fits and looks great.
bustersmaster is offline  
 
Page generated in 0.04253 seconds with 7 queries