View Single Post
Old March 31, 2013, 07:50 PM   #12
Lemmon
Senior Member
 
Join Date: December 25, 2009
Location: Rural South Carolina
Posts: 412
Decaping Sellier & Bellot 9mm brass

A few years ago I bought a couple thousand 9mm brass and about 3 or 4% were Sellier & Bellot. I removed the primers in batches and started to prime them. I did notice that the Sellier & Bellot brass were harder to deprime than the others. I also had trouble priming them. Some would prime ok but learned most were a problem. I decided to remove these trouble makers from my pile.

I went through and sorted the Sellier & Bellot brass and used a RCBS tool designed to remove military crimps. This allowed me to save them and be successful in repriming them.

Lemmon from Rural South Carolina...
Lemmon is offline  
 
Page generated in 0.04294 seconds with 7 queries