View Single Post
Old March 31, 2013, 01:02 PM   #10
jag2
Senior Member
 
Join Date: June 30, 2009
Location: dallas
Posts: 400
"I checked the fit and discovered the pin would not fit all the way into the flash hole." Trying to figure this out, are you saying the end of the pin is tapered so that only the tip of it will enter the hole? Most pins I've seen are rounded on the end but not tapered. Will the pin fit in the flash hole if you try it from the other side thru the primer pocket? On a different topic, do you know where you will be doing most of your shooting? 9mm is so common that I guarantee you I come home from the range with more brass than I took. There are plenty of shooters using factory ammo that are more than happy to let you pick up their brass (best to ask first) so it may not be necessary to buy that much brass.
jag2 is offline  
 
Page generated in 0.04789 seconds with 7 queries