View Single Post
Old March 31, 2013, 12:07 PM   #60
Doc Hoy
Senior Member
 
Join Date: October 24, 2008
Location: Chesapeake, VA
Posts: 4,573
Dovetailing the front sight

I made this sight and now I am afraid it might be too short.

Clamping this to the milling machine table was a bear. I had to be SOOO careful to get the alignment right.



I cold blued the barrel, and receiver to try to get them to match.



Only just so successful. I might try that again.

Here is the closeup of the sight.

__________________
Doc

My reading of history convinces me that most bad government results from too much government. Thomas Jefferson
Doc Hoy is offline  
 
Page generated in 0.04802 seconds with 7 queries