View Single Post
Old March 31, 2013, 11:45 AM   #5
GRCummins
Junior Member
 
Join Date: March 24, 2013
Location: Norfolk, VA
Posts: 5
Thanks HJ, the trigger assembly area is exactly where I see the problem to be. No doubt I want it to be tight fit, but I have 3/16" to 1/4" of shaving to get the back end of the receiver to be able to meet the trigger assembly.
I just wanted to get clarification from others with experience before I start manipulating my new stock.
I was also experiencing difficulty removing the pin at the hand guard area. Any thoughts on that so that I dont destroy the gas tube?
Thanks for your input.
Greg
GRCummins is offline  
 
Page generated in 0.06089 seconds with 7 queries