View Single Post
Old March 30, 2013, 09:38 PM   #7
93Harley
Junior Member
 
Join Date: March 30, 2013
Posts: 12
Thanks for the help

I have been using the Lee Reloading Dies which has the Carbide sizing die with the decaping pin set in the middle. The cases only have one small hole in the middle. At least on the two cases I have been able to punch. I will check the depth of punch and pin straightness before I make another attempt. Before I mounted the new pin in the die, I checked the fit and discovered the pin would not fit all the way into the flash hole. Now I'm concerned that even though I could remove the primer and get a new one in, is the flash hold too small to allow for proper powder ignition by the primer? And if I drill the flash hold to a larger diameter, will that affect anything?
93Harley is offline  
 
Page generated in 0.04289 seconds with 7 queries