View Single Post
Old March 30, 2013, 08:28 PM   #3
m&p45acp10+1
Senior Member
 
Join Date: May 3, 2009
Location: Central Texas
Posts: 3,310
Are you using a decapping pin die, or the sizing/decap die?

I have had no problems with decapping it with a standard sizing/decap die. Some are crimped primer pockets. You will notice when priming if they are. It will feel like you are trying to push a bowling ball through the tail pipe of your car if it is crimped. If so put the brass to the side for removing the primer pocket crimp. Lyman makes a hand tool for it that cost less than $20 and takes a few seconds. Or RCBS makes primer pocket swage that goes on the press and presses a rod to remove the crimp.
__________________
No matter how many times you do it and nothing happens it only takes something going wrong one time to kill you.
m&p45acp10+1 is offline  
 
Page generated in 0.04729 seconds with 7 queries