View Single Post
Old March 28, 2013, 10:00 AM   #16
howlnmad
Senior Member
 
Join Date: April 29, 2009
Location: Harriman Tn
Posts: 413
"Fired (or tried to) my first rounds today. Hadn't noticed (got to look into that) that some of the cases had ring bulges on them and wouldn't load into the cylinder. I assume that is because I am caming over on the resizing die. Anyway, I will inspect the cases after each operation until I get the dies set up correctly."


Where exactly are these bulges? Any chance of posting a picture?
howlnmad is offline  
 
Page generated in 0.04031 seconds with 7 queries