View Single Post
Old March 27, 2013, 06:57 PM   #14
balderclev
Senior Member
 
Join Date: March 20, 2013
Location: Benton, Arkansas
Posts: 100
Fired (or tried to) my first rounds today. Hadn't noticed (got to look into that) that some of the cases had ring bulges on them and wouldn't load into the cylinder. I assume that is because I am caming over on the resizing die. Anyway, I will inspect the cases after each operation until I get the dies set up correctly.
balderclev is offline  
 
Page generated in 0.04415 seconds with 7 queries