View Single Post
Old March 25, 2013, 09:35 PM   #7
balderclev
Member
 
Join Date: March 20, 2013
Location: Benton, Arkansas
Posts: 96
Thanks so much for all the comments and advice. I managed to get a hundred brass ready for powder and bullets which should be in tomorrow.

I did vary a bit from the instructions on the sizing die so that I slightly cam over.

I am assuming that since I will be loading jacketed bullets that the post-sizing function of the FCD would not be appropriate.

Again, thanks for all the info. I do try to research as much as possible before asking questions here, but the Q&A I get here really clears issues up for me.
balderclev is offline  
 
Page generated in 0.05014 seconds with 7 queries