View Single Post
Old March 25, 2013, 06:58 PM   #5
everest
Member
 
Join Date: March 24, 2013
Posts: 15
I spoke with Thompson Center and they want to have a look at the barrel, so off it goes later this week. I will try removing the extractor pin before I send it back because I do have a suspicion that it is putting too much pressure on the case as it slides in/out. More play when inserting it means it doesn't matter so much, but after the brass has been fired I think it matters.

Anyways, once that pin is out if the brass is still sticky then it's definitely the barrel.

-Jeff
everest is offline  
 
Page generated in 0.04891 seconds with 7 queries