View Single Post
Old March 25, 2013, 01:51 PM   #8
aarmel732
Member
 
Join Date: October 15, 2012
Location: Illinois
Posts: 67
http://www.midwayusa.com/product/639...-polymer-clear

Here is a link to the mags I am using. You can see really well the part that is facing you with the spring in it. The top clear (nearest the gray that goes in the magwell) needs to be ground down. I got it down to about where the spring anchors inside. Then I used some epoxy to cover over and smooth the grinding marks, and went all the way around the juction between the gray and clear portions.
aarmel732 is offline  
 
Page generated in 0.04165 seconds with 7 queries