View Single Post
Old March 20, 2013, 05:27 PM   #10
Senior Member
Join Date: May 24, 2011
Posts: 986
Please note

When you're reading bbti graphs account for this

in every case with the T/C Encore the length of the barrel was measured from the end of the barrel back to the breech face. This is how semi-auto pistols are measured, but revolvers are measured as the length of the barrel in front of the cylinder gap. Take this into consideration when comparing calibers using our numbers.

I have a S&W 327 NG and its a blast to shoot. Magnum loads are by far more fun than .38spl.
M&P- the other dark meat
RamItOne is offline  
Page generated in 0.04245 seconds with 7 queries