View Single Post
Old March 18, 2013, 01:41 PM   #33
ViktorC
Member
 
Join Date: August 3, 2011
Posts: 15
"alignment of the case" is something I did think of, also very possible...I am using Lee 4 hole turret press and if it's out of alignment I can see case coming out like that...I always make sure that case is pushed all the way into the shell holder to have it entering the die straight up...but that wouldn't avoid this scrapes if the turret itself is not aligned ...which I was not able to see
ViktorC is offline  
 
Page generated in 0.04574 seconds with 7 queries