View Single Post
Old March 18, 2013, 12:36 PM   #1
craZivn
Senior Member
 
Join Date: January 25, 2013
Location: Wisconsin
Posts: 138
SP-101 Owners: Do All SPs Do This?

Just noticed that when I pull the trigger in double-action mode, the trigger housing moves away from the frame just slightly. Just enough to slip a bit of paper into the crack:



It happens also on the left side of the gun, but to a lesser extent. The gap disappears when the trigger hits full-reset.

Does everyone else's SP101 do this too, or is it something I should keep an eye on?

The gun shoots perfectly.
I did fully disassemble and polish the internals, but I only used a soft Dremel wheel with rouge, so there's no chance I could have deformed any of the parts. Installed something backwards, maybe.

If y'all could check your guns and see if this is normal, I'd appreciate it much!

Thanks,
Ivan
craZivn is offline  
 
Page generated in 0.04294 seconds with 7 queries